English (GB)
12
6.1.3 Connecting the battery and power supply
These safety precautions must be observed:
- Only insert the approved Grundfos battery pack (97631960).
- Never use this battery pack in other battery chargers.
- Do not dismantle or modify the battery.
- Do not heat or incinerate the battery.
- Do not pierce, crush or cause mechanical damage to the
battery.
- Do not short-circuit the battery.
- Do not allow the battery to get wet or be immersed in water.
- Do not strike or throw the battery.
- For long periods of storage, the temperature must be below
35 °C.
You can fit CIM 260 with a lithium-ion battery (order no.
97631960), which ensures sustained cellular connection with the
product in which it is mounted, even if the power is switched off.
The battery is secured by a velcro strap which absorbs vibrations
and simplifies replacement. Connect the battery to CIM260 as
shown in fig. 21.
Fig. 21 Connecting the battery
Switch on the power supply. CIM 260 is powered either by CIU
260 or by the battery.
LED1 flashes yellow, searching for cellular network. When the
connection to the cellular network has been established, LED1
pulsates yellow: the cellular network is active. See fig. 22.
LED2 is permanently green, indicating that you have fitted CIM
260 correctly in CIU 260.
6.1.4 Configuration
For software configuration of CIU 260, which includes setting of
SMS functions and SCADA communication parameters, see "CIM
260 SMS commands", which you can download from Grundfos
Product Center.
6.2 LEDs
The CIM 260 module has two LEDs. See fig. 18.
• Yellow and green status LED1 for cellular communication
• Red and green status LED2 for internal communication
between CIM 260 and the booster system.
LED1, yellow and green
Fig. 22 LED1 status
LED2 (red and green)
WARNING
Electric shock
Death or serious personal injury
- Connect CIM 260 only to SELV or SELV-E circuits.
WARNING
Flammable material
Death or serious personal injury
- The safety precautions listed below must be
observed carefully as improper handling of the
lithium-ion battery may result in injury or damage
from electrolyte leakage, heating ignition or
explosion.
If a battery is not connected, the user will not receive
any information in case of a power cut.
TM07 1664 2418
You can only charge the battery if the battery
temperature is within 0 to 45 °C.
TM04 5194 4412
Pos. Status Description
1 Flashing yellow Searching for cellular network.
2
Pulsating yellow,
single pulse
Connection to the cellular
network has been established.
3 Permanently yellow
Call-up connection has been
established.
4
Pulsating green,
single pulse
Communication via data
connection.
5
Pulsating green,
double pulse
Communication via the call-up
connection.
6 Green (3 sec.)
Sending or receiving an SMS
message.
Status Description
Off CIM has been switched off.
Flashing red
No communication between CIM 260 and
the booster system.
Permanently red
The CIM 260 does not support the
connected version of the booster system.
Permanently
green
The connection between CIM 260 and the
booster system is OK.
1 second
3 seconds
1
6
4
5
3
2
Yellow
Green
To Next Page
Loading...
Need help?
General
