8.7.3 Dry-material feeder calibration
This menu guides you through the calibration procedure for the dry-
material feeder.
Menu action Required user level
Access menu
Change settings
1 System Operator
PD412E-D1260
Fig. Start-up dry-material feeder
CAUTION
Crushing of hands
Minor or moderate personal injury
‐ After removing the dissolving hopper, do not reach into
the dosing screw. The dosing screw starts running
when you switch on the dry-material feeder.
TM072373
For removing the dissolving hopper, see Checking and cleaning the
dissolving hopper
Perform the procedure step by step as described in the menu. Each
main step requires several sub steps.
Symbol
Description
Push these symbols to navigate through the main
steps.
Push these symbols to switch on or off the dry-
material feeder.
• Green: Switched on
• White: Switched off
Push this symbol to start the automatic calculation
of the dosing capacity.
Push this symbol to revert to the previous menu.
25
English (GB)
To Next Page
Loading...
Need help?
General
