Grundfos RSI - Page 59

6.2.6 User settings
Code Parameter Min Max Unit Default ID Description
P6.1 Language selections Varies Varies Varies 802
Depends on language
package.
P6.2 Application selection 801
M6.5 Parameter backup See chapter Parameter backup below.
P6.7 Drive name Give name of drive if needed.
Parameter backup
Code Parameter Min Max Unit Default ID Description
P6.5.1
Restore factory
defaults
831
Restores default parameter
values and initiates the
Startup Wizard when
activated
P6.5.2 Save to keypad 0 1 0
Save parameter values to
keypad to e.g. copy them to
another drive.
0 = No
1 = Yes
P6.5.3 Restore from keypad
Load parameter values from
keypad to the drive.
B6.5.4 Save to Set 1
Store a customised
parameter set (all parameters
included in the application)
B6.5.5 Restore from Set 1
Load the customised
parameter set to the drive.
B6.5.6 Save to Set 2
Store another customised
parameter set (all parameters
included in the application)
B6.5.7 Restore from Set 2
Load the customised
parameter set 2 to the drive.
59
English (GB)