Grundfos RSI - Page 69

Code Monitoring value Unit Scale ID Description
V2.6.11 LastActiveAlarmCode 1 74
The alarm code of latest activated alarm
that has not been reset.
V2.6.12 LastActiveAlarm ID 1 94
The alarm ID of latest activated alarm that
has not been reset.
V2.6.13 MotorRegulat.Status 1 77
Motor limit controller status.
Checked = limit controller is active,
Unchecked = limit controller is not active
7.1.6 Timer functions
Here you can monitor values of timer functions and
the Real Time Clock.
Code Monitoring value Unit Scale ID Description
V2.7.1 TC 1, TC 2, TC 3 1 1441
Possible to monitor the statuses of the
three Time Channels (TC)
V2.7.2 Interval 1 1 1442 Status of timer interval
V2.7.3 Interval 2 1 1443 Status of timer interval
V2.7.4 Interval 3 1 1444 Status of timer interval
V2.7.5 Interval 4 1 1445 Status of timer interval
V2.7.6 Interval 5 1 1446 Status of timer interval
V2.7.7 Timer 1 s 1 1447 Remaining time on timer if active
V2.7.8 Timer 2 s 1 1448 Remaining time on timer if active
V2.7.9 Timer 3 s 1 1449 Remaining time on timer if active
V2.7.10 Real time clock 1450 hh:mm:ss
7.1.7 PID Controller
Code Monitoring value Unit Scale ID Description
V2.8.1 PID set point Varies
According to
P3.13.1.7
20
PID controller set point value in process
units. Process unit is selected with a
parameter.
V2.8.2 PID feedback Varies
According to
P3.13.1.7
21
PID controller feedback value in process
units. Process unit is selected with a
parameter.
V2.8.3 PID error Varies
According to
P3.13.1.7
22
PID controller error value. Deviation of
feedback from set point in process units.
Process unit is selected with a
parameter.
V2.8.4 PID output % 0.01 23
PID output in percent (0..100 %). This
value can be fed e.g. to Motor Control
(Frequency reference) or Analogue
output
V2.8.5 PID status 1 24
0 = Stopped
1 = Running
3 = Sleep mode
4 = In dead band
69
English (GB)