Code Parameter Default ID Description
P3.5.1.52 Energy Counter reset DigIN Slot0.1 1933 Energy Counter reset
P3.5.1.53 Mains supply on DigIN Slot0.1 1934 Mains supply on
P3.5.1.54 Flowmeter pulse DigIN Slot0.1 1953 Digital input for pulse flow meter (P3.23.1 = 1)
P3.5.1.55 Volume counters reset DigIN Slot0.1 1957 Digital input for Volume counters reset
P3.5.1.56 Minimum water level DigIN Slot0.2 1963 Digital input for minimum water level in the well
P3.5.1.57 Minimum level logic
Level ok =
input high
1965
Selections for minimum water level logic:
0 = water level is ok when digital input for
Minimum water level is high
1 = water level is ok when digital input for
Minimum water level is low
The drive trips with F63 (Low water level) when
water level is not ok. The fault is reset with
autoreset logic of Underload (see P3.10.5 - 8)
when level is restored.
Min level signal/fault refers to level in a well
from which water is taken.
P3.5.1.58 Maximum water level DigIN Slot0.2 1966
Digital input for maximum water level in the
well
P3.5.1.59 Maximum level logic
Level ok =
input high
1967
Selections for maximum water level logic:
0 = water level is ok when digital input for
Maximum water level is high
1 = water level is ok when digital input for
Maximum water level is low
The drive trips with F64 (Max water level)
when water level is not ok. The fault is reset
with autoreset logic of Underload (see P3.10.5
- 8) when level is restored.
Max level signal/fault refers to level in a
possible tank where pumped water is stored.
P3.5.1.60 Dual Supply Enable DigIN Slot0.2 1991
Digital input high enables relay for the AC
switch connection and Dual supply mode
logics.
P3.5.1.61 DualS M2Check Disable DigIN Slot0.1 1989
Digital input high disables the periodic Mode 2
DC voltage check, when Dual supply Mode 2
sensorless is active.
88
English (GB)
To Next Page
Loading...
