English (GB)
14
8.3.1 Accessing the expert settings
Proceed as follows:
1. Hold down the button for five seconds.
2. The symbol will start flashing to indicate that
the expert settings are active.
The pressure indicator now acts as the expert
"menu". A flashing green diode is the cursor. Move
the cursor using the buttons, and toggle the
selection on or off using the button. The diode
for each setting will light up when the setting is
active.
Fig. 16 Expert "menu" overview
8.3.2 Auto reset
The factory setting for "Auto reset" is "on".
On:
This function allows the pump to automatically check
if the operating conditions are back to normal. If the
operating conditions are back to normal, the alarm
indication will be reset automatically.
The "Auto reset" function works in the following way:
For indications, see section 7.1.2 Indicator lights,
SCALA2.
Off:
All alarms must be reset manually by means of the
button.
8.3.3 Anti cycling
The factory setting for "Anti cycling" is "off".
This function monitors the stops and starts of the
pump.
Off:
If the pump starts 40 times in a fixed pattern, there
will be an alarm. The pump will remain in operation
as normal.
On:
If the pump starts and stops in a fixed pattern, there
is a leakage in the system, and the pump will stop
and show alarm 3.
Move cursor up
Move cursor down
Toggle settings
TM06 4346 2015
Auto reset
Anti cycling
operating time
Exit expert "menu"
Indication Action
Water shortage
The pump will attempt eight
restarts at five-minute intervals.
If not successful, this cycle will
be repeated after 24 hours.
Dry running
(pump not
primed)
Prime the pump and reset it
manually.
All other
indications
The pump will attempt three
restarts within the first 60
seconds, then eight restart
attempts at five-minute intervals.
If not successful, this cycle will
be repeated after 24 hours.
Leakage in the system.
To Next Page
Loading...
Need help?
General
