13
English (US)
If the pump still does not deliver a sufficient
quantity of water, dismantle the pump as follows:
1. Disconnect the power supply.
2. Turn the pump housing 90 °
counterclockwise using a screwdriver. See
the arrow on the pump housing. Pull off the
housing. See fig. 11.
Fig. 11 Removing the inlet strainer from the
pump housing
3. Clean and flush the pump with water to
remove possible impurities between the
motor and the outer pump housing. Clean
the impeller. See fig. 12.
Fig. 12 Cleaning the impeller
4. Check that the impeller can rotate freely. If
not, remove the impeller:
– Loosen and remove the nut on the motor
shaft (13 mm). Use a screwdriver to
prevent the impeller from rotating. See fig.
13.
– Clean the impeller and the area around the
shaft.
Fig. 13 Removing the impeller
5. Check the impeller, the pump housing and
the sealing part. Replace possible defective
parts.
6. Assemble the pump in reverse order of
dismantling.
TM03 1168 1205
TM03 1169 1205
TM03 1170 1205
Check before and when fitting the
pump housing that the sealing part is
positioned correctly, see fig. 14.
Moisten the sealing part with water to
facilitate the fitting.
To Next Page
Loading...
Need help?
General
