Grundfos UPMS - Setting of the Product

9. Setting of the product
Press the button to select external signal type (if relevant) or
constant-curve setting (I, II or III). The LEDs will indicate the control
mode. See the table below.
Note that the LED for the chosen setting flashes to indicate that it is
active.
Models without external signal: A cycle is 3 button presses.
Models with external signal: A cycle is 5 button presses.
LED Control mode
TM084188
Setting I
TM084189
Setting II
TM084190
Setting III
TM084191
0-10 V
TM084192
PWM
17
English (US)