PNEG-750-G2 16" Series II Sweep 131' and 135' Diameter 61
7. Operation
Operating the Sweep Auger
NOTE: The auger capacity can fluctuate greatly under varying conditions. Moisture content, different
commodities, amount of foreign matter and speeds all play a part in the performance of the
auger. Twenty-five percent (25%) moisture may cut capacity by as much as 40% under
some conditions.
A. Make certain there are at least two (2) people in the work area to monitor operations at all times.
B. Start the bin unloading equipment before starting the bin sweep auger.
C. Shut down the auger as soon as the bin is empty.
D. Consideration should be given to the proper size auger for any intermittent type operations. When
augers are stopped and restarted under full load, it may result in damage to the auger. Using a
larger diameter auger and reducing its load level will be far better than subjecting a smaller
diameter auger to big loads. If an auger is kept from absolute filling, it will make start-up easier and
will convey more efficiently.
Gear reducer is shipped without oil. Add the proper amount of the recommended
lubricant before operating. Failure to observe these precautions could result in
damage to, or destruction of, the equipment.
Keep out of the bin while the bin sweep auger is in operation. The rapidly moving
sweep auger can cause SERIOUS INJURY or DEATH.
Be alert for any unusual vibrations, noises and the loosening of any fasteners. If
anything unusual is detected, immediately shut down the auger, disconnect and
lock out the power source before servicing.
NEVER enter the bin while the bin sweep is in operation.
NEVER attempt to control the operation of the bin sweep by depressing the
operating controls with shovels, brooms or any other objects.
DO NOT attempt to restrain movement of the bin sweep with ropes, bars or
other devices.
NEVER allow an operator to attempt to manually restrain the bin sweep.
To Next Page
Loading...
Need help?
General
