Gtech ST04 - Important Safety Information

IMPORTANT:
FOR YOUR OWN SAFETY AND
BYSTANDERS READ THE
INSTRUCTIONS BEFORE OPERATING
THE MACHINE.
PLEASE KEEP THE INSTRUCTIONS
SAFE FOR FUTURE REFERENCE.
WARNING: When using the machine the
safety instructions must be followed.
WARNING: THIS PRODUCT CAN CAUSE
SERIOUS INJURIES.
Read all instructions. Failure to follow
all instructions listed below may result in
electric shock, re and/or serious injury.
The term “power tool” in all of the warnings
listed below refers to your mains-operated
(corded) power tool or battery-operated
(cordless) power tool.
WARNING:
When using any electrical appliance,
basic safety precautions should always be
observed, including the following, to reduce
the risk of re, electrical shock, or injury.
Work area:
•Keep work area clean and well lit.
Cluttered and dark areas invite accidents.
•Do not operate power tools in explosive
atmospheres, such as in the presence of
ammable liquids, gases or dust. Power
tools create sparks which may ignite the
dust and fumes.
•Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
•Not to be used as a toy. Not to be used
near children. Never allow children to use
the power tool. When not in use store the
power tool out of the reach of children.
•Always be sure of your footing on ladders
or slopes, do not over-reach or use on
excessively steep slopes.
Electrical safety:
•Power tool plugs must match the outlet.
Never modify the plug in any way.
•Do not use any adaptor plugs with
earthed (grounded) power tools.
Unmodied plugs and matching outlets
will reduce the risk of electric shock.
•Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators. There
is an increased risk of electric shock if
your body is earthed or grounded.
•Do not expose power tools to rain or wet
conditions. Water entering a power tool
will increase the risk of electric shock.
•Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging the
power tool. Keep cord away from heat,
oil, sharp edges or moving parts.
Damaged or entangled cords increase the
risk of electric shock.
•When operating a power tool outdoors,
use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
•If the cord becomes damaged during use
disconnect the cord from the power supply
immediately- DO NOT touch the cable
before disconnecting.
•Before use check the power supply and
charger cables for signs of damage or
ageing.
•When charging or operating the power
tool it is recommended that the appliance
should be supplied via a residual current
device (RCD) with a tripping current of not
more than 30mA.
•Do not handle the charger or the power
tool with wet hands.
Personal Safety:
•Stay alert, watch what you are doing
and use common sense when operating
a power tool. Do not use any power tool
while you are tired or under the inuence
of drugs, alcohol or medication. A moment
Important Safety Information
3 Gtech helpline: 0870 7944001 email: support@greytechnology.co.uk
www.greytechnology.co.uk