GTO 2002XLS - Installing the Gate Operator; Attaching Post and Gate Brackets

8 GTO 2002XLS Instruction Manual © 01.12.12
Clevis Pin
Hairpin Clip
Post Bracket Assembly
Bushing
Rear Mount
Operator
Clevis Pin
Hairpin Clip
Gate Bracket
Front Mount
Bushing
Level Operator
Fence Post
Gate In Open Position
LEVEL horizontal cross member
Post Bracket Assembly
Gate Bracket
Step 1
Insert the 3/8" x 2" bolt through the center hole of the post
brackets and post pivot bracket as shown. Fasten a 3/8"
lock washer, 3/8" washer and 3/8" nut on the end of the bolt.
DO NOT overtighten the nut because the post pivot bracket
will have to be adjusted later.
3/8" x 2" Bolt
3/8" Nut
Post Pivot Bracket
Post Bracket
Post Bracket
3/8" Lock Washer
3/8" Washer
Step 2
Attach post bracket assembly to the rear mount of the opener
with a clevis pin and a 3/8” washer. Secure the clevis pin with a
hairpin clip.
Step 3
Attach gate bracket to the front mount of the opener with a
clevis pin and a 3/8” bushing. Secure the clevis pin with a
hairpin clip.
Step 4
With the gate in the fully open position and the opener arm fully retracted, adjust the post bracket assembly
and gate bracket until the opener is level. While holding the opener level, use C-clamps to temporarily
secure the post bracket assembly and gate bracket to the post and gate.
Install the Operator