11
11.2.2 HOW TO PROGRAM “PART SET” (AT HOME) CIRCUITS
To program circuits as PART SET circuits:
Either
1. Ensure that the panel is unset and that no circuits are alarmed.
2. Hold the 3 key down for 2 seconds. (The keypad will “beep” and the ready and
tamper leds will flash together).
3. Now select the circuits that you require to be PART SET circuits by pressing
the key corresponding to the circuit number. The PART SET circuits will be
indicated by the corresponding circuit leds being on permanently. (Note: Any
DELAYED ALARM circuits that have been programmed will be indicated by
flashing circuit leds).
4. Press the # key to exit this mode.
OR
1. Ensure that the panel is unset and that no circuits are alarmed.
2. Hold the 3 key down for 2 seconds. (The keypad will “beep” and the ready and
tamper leds will flash together.)
3. Walk through the areas that you will use when the panel is PART SET. The
PIR sensors will detect your movement and bypass these circuits
automatically. The PART SET circuits will be indicated by the corresponding
circuit leds being on permanently.
4. Press the # key to exit this mode.
11.2.3 HOW TO CANCEL A "PART SET” CIRCUIT
It may become necessary to clear or de-select a PART SET circuit. For example, a
bedroom may become unused and may need to be protected during PART setting.
To deselect a PART SET circuit:
1. Ensure that the panel is unset.
2. Hold the 3 key down for 2 seconds. (The keypad will “beep” and the ready and
tamper leds will flash together).
3. The PART SET circuits will be indicated by circuit leds being on permanently.
4. Cancel the circuit or circuits concerned by pressing the key corresponding to
the circuit number.
5. Press the # key to exit this mode when completed.
Note: The control panel will automatically exit this mode after 60 seconds if no keys
are pressed.
To Next Page
Loading...