5
2.2 PART SET (SETTING WHILE AT HOME)
To PART SET the panel:
1. Verify that the READY led is on.
2. Make sure the front door is closed.
3. Enter your user code.
4. DO NOT open the front door.
5. All LEDs, except POWER will extinguish and the keypad buzzer will sound
on/off for the duration of the exit time.
6. Any PART SET circuits will be automatically bypassed. Once the panel is
PART SET, ensure that you only enter those circuits that are bypassed.
NOTE: See section on how to program PART SET circuits and section on how to program
DELAYED ALARM circuits. It is important to set the entry/exit circuit (front door) as a
DELAYED ALARM circuit if you expect anyone to enter after the alarm has been PART SET
(usually later at night).
2.3 QUICK PART SET
To PART SET the panel quickly:
1. Verify that the READY led is on.
2. Press the # key once then depress the 5 key for 2 seconds until the keypad
beeps.
3. The leds will extinguish and any PART SET circuits will be automatically
bypassed.
4. The panel is now PART SET. Ensure that you only enter those circuits that
are bypassed.
NOTE: See section on how to program PART SET circuits and section on how to program
DELAYED ALARM circuits. It is important to set the entry/exit circuit (front door) as a
DELAYED ALARM circuit if you expect anyone to enter after the alarm has been PART
SET (usually later at night).
2.4 PART SET (WITH ENTRY/EXIT POINT)
Allows you to set the alarm, exit the premises and set into the PART SET mode. This is
useful when exiting while someone stays at home.
1. Verify that the READY led is on.
2. Press the # key once then depress the 6 key for 2 seconds until the keypad
beeps.
3. The leds will extinguish, and the keypad buzzer will sound on/off for the
duration of the exit time. Any PART SET circuits will be automatically
bypassed. The setting process has started.
4. Leave immediately only via the designated entry route and entry/exit circuits.
To Next Page
Loading...