Guardall Pi-8 - 3 Problems When Setting the Panel; The Panel will Not Set When You Enter Your Code; Is the Code Correct; Is the Ready Led on

6
3. PROBLEMS WHEN SETTING THE PANEL
3.1 THE PANEL WILL NOT SET WHEN YOU ENTER YOUR CODE!
3.1.1 IS THE CODE CORRECT?
If you enter the wrong code, the keypad buzzer will beep three times.
3.1.2 IS THE READY LED ON?
If the ready led is not on, then one or more circuits are alarmed. The corresponding
circuit leds will be flashing. Check these circuits to see that all windows and doors
that have sensors are properly secured.
NOTE: Bypassing circuits which are alarmed will also create a READY condition.
3.1.3 HAS THE ENGINEER’S RESET CODE BEEN ENABLED?
If the engineer’s reset code has been enabled, the panel cannot be set again after
an alarm condition has occurred until your installer has reactivated it.
3.1.4 DOES THE SOUNDER ACTIVATE BEFORE YOU EXIT?
Either the exit time is too short (ask your installer to increase the exit time) or you
have not left via an entry route (avoid these circuits in future, or if this is impractical,
have your installer change the circuit to an entry route).
3.1.5 IS THE TAMPER LED ON?
If the tamper led is on, the panel will not set. If the tamper is removed, entry of a
valid user code will clear this condition. If the tamper led does not extinguish, it
means that there is a still a tamper condition. In this event contact your alarm
installer.