7
4. HOW TO UNSET THE PANEL
If you are entering the premises from outside:
1. Enter ONLY via the ENTRY/EXIT circuit and then go directly to the keypad.
2. Upon entering, the keypad will “beep” to indicate that the entry time has started.
3. Enter # followed by your 4 digit user code. The keypad will stop beeping.
4. The panel is now unset.
If you are INSIDE the home and need to unset:
1. Go directly to the keypad and enter your user code.
2. The panel is unset.
If either circuits were bypassed and/or an alarm condition occurred while the system was
set, the alarm memory will be displayed immediately after the system is unset. Alarmed
circuits will be indicated by flashing circuit leds and bypassed circuits will be indicated by
circuit leds being permanently on. The alarm memory may be cleared by pressing the #
key.
5. PROBLEMS WHEN UNSETTING THE PANEL
5.1 THE SOUNDER ACTIVATES IMMEDIATELY UPON ENTRY.
Either, you have not entered via the entry/exit circuit or you have entered whilst the panel
is PART SET. (Have the entry/exit circuit programmed as a DELAYED ALARM circuit).
5.2 THE SOUNDER ACTIVATES BEFORE YOU GET TO THE KEYPAD.
Either you have entered an alarm circuit or you have exceeded the entry time.
5.3 THE PANEL WILL NOT UNSET.
By now, the sounder may have also been activated.
Check that your user code is correct.
6. SETTING AND UNSETTING USING A KEYSWITCH
This option is NOT standard. Check with your installer to verify installation.
To SET the panel:
1. Before leaving, check that the READY led is on. (If not, see section 3 on
PROBLEMS WHEN SETTING).
2. Leave and close the door.
3. Turn the key-switch to the set position.
4. The panel will set.
To UNSET the panel:
1. Turn the key-switch to the unset position.
2. The panel will unset.
To Next Page
Loading...