Guardall PX18 - Failure to Set after Exit Time

PX Control Panel User Manual – Issue C
- 19 -
4=Force Set Press the 4 button to try to force set.
If the circuits in fault can be bypassed then the system will report the bypassed circuits and then prompt
the user to confirm setting.
Failure to Set after Exit Time
If the group fails to set at the end of the exit period, the exit tone will change to warn the user that the
system has not set. Log on to the keypad to display the fault condition(s). The external sounder may
also have been programmed by the installation engineer to activate in the event of a failure to set.
Intelligent Security & Fire Ltd