PX Control Panel User Manual – Issue C
- 36 -
Note: If the software versions supports auxiliary PSUs then the following messages will be logged with a
number:
• Battery Low
• 230v Fault
• 230v OK
• Power Fail
• Bat.Monitor Fail
The number represents the PSU device:
Logged Number Device
0 Control Panel
1-max concs Concentrator number
Max concs-max concs + max
access modules
Access module number
Access log only messages
Log Text Additional Data Display Text Event Description
Access User nn, Door m Usnn, Doorm User accessed door m
Denied User nn, Door m Usnn, Doorm User denied access door m
Set Req. User nn, Door m Usnn, Doorm User request to set from door m
Unset Req. User nn, Door m Usnn, Doorm User request to unset from door
m
Exit User nn, Door m Usnn, Doorm User exit by door m
Door Open Door m Doorm Door held open
Forced Door m Doorm Door forced open
Unlock Door m Doorm Door unlocked
Lock Door m Doorm Door lock
Pending Door m Doorm Schedule unlock pending
RTE Door m Doorm Door RTE button active
Time
Code-20
The clock can only be set by the engineer. Some users have the authority to change the time by up to
75 minutes from the time set by the engineer if the user clock edit option is programmed.
Time
12:00 To change, start entering the new time
Time
Enter HH:MM Enter the new time
The old and new times will be recorded in the event log.
Intelligent Security & Fire Ltd
To Next Page
Loading...
