GW Instek GDS-3152 - Page 59

MEASUREMENT
59
Before
After
3. To undo Autoset, press Undo
Autoset from the bottom menu.
To remove the Undo Autoset
softkey, press any other key.
Change modes
1. Choose between Fit Screen Mode
and AC Priority Mode from the
bottom menu.
2. Press the Autoset key again to use
Autoset in the new mode.
Autoset
Fit Screen Mode
AC Priority
Limitation
Autoset does not work in the following situations.
 Input signal frequency is less than 20Hz
 Input signal amplitude is less than 30mV