GW Instek GDS-3152 - Autoset

GDS-3000 Series User Manual
58
Default Setup
To activate the default state,
press Default Setup.
Default
Setup
Autoset
The Autoset key (page 58) does NOT automatically
activate the channels to which input signals are
connected.
Autoset
Background
The Autoset function automatically configures the
panel settings to position the input signal to the
best viewing condition. The GDS-3000
automatically configures the following parameters.
 Horizontal scale
 Vertical scale
 Trigger source channel
There are two operating modes for Autoset
function: Fit Screen Mode and AC Priority Mode.
Fit Screen Mode will fit the waveform to the best
scale, including any DC components (offset). AC
priority mode will scale the waveform to the
screen removing any DC component.
Panel Operation
1. Connect the input signal to the
GDS-3000 and press the Autoset
key.
Autoset
2. The waveform appears in the center of the
display.