OPERATION
19
4. Ensure the tester is in the READY status.
5. Press the START button when the tester is in the
READY status. The AUTO test starts
automatically and the display changes to each
MANU step test in sequence until the last MANU
step test is finished or stopped.
If Double Action is ON, ensure the START button is
pressed immediately after the STOP button was
pressed within 0.5s.
If INTERLOCK is set to ON and the interlock key is
not connected to the SIGNAL I/O port, Interlock
Open message will be displayed on the screen to
prevent the test from starting for safety concern.
A protection setting has been tripped; when a
protection setting has been tripped the
corresponding error message is displayed on the
screen. Refer to the User Manual for a
comprehensive list of the all the error messages.
To Next Page
Loading...
Need help?
General
