GW Instek PSU 150-10 - Page 76

PSU Series User Manual
76
Master-Slave
Operation
Only operate the power supplies in parallel if the
units are configured correctly.
Steps
1. Turn on the master and slave units. The slave
unit(s) will show a blank display.
Master unit
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
Slave units
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
2. Operation of all units is controlled
via the master unit. Operation of
the master unit is the same as for a
single unit. See the Basic Operation
chapter.
Page 49.
3. Press the Output key to
begin. The output LED will
become lit.
Output
Caution
Only operate the power supplies in parallel if using
units of the same model number.
Note
The panel controls are disabled on slave units,
including the output key. On slave units, only the
Function key can be used to view the current settings.