GW Instek PSU 150-10 - Setting the Test Script Settings

OPERATION
87
Setting the Test Script Settings
Steps
The test script settings (T-01~T-10) are set with the
Test key.
1. Press the Test key. The Test key
will light up.
TEST
2. The display will show T-01 on the left and the
memory no. for T-01 on the right.
The middle of the display will indicate if the
desired file is available in memory or not. Y
indicates Yes, N indicates No.
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C
V A
Test number Test setting
Available Y/N
3. Rotate the Voltage knob to change
the T setting (Test setting).
Voltage
Test Run
Test Copy
Test Export
Test Remove
T-01
T-02
T-03
T-04