GW Instek PSW 30-108 - Page 117

CONFIGURATION
117
Setting Power On Configuration Settings
Background
The Power On configuration settings can only
be changed during power up to prevent the
configuration settings being inadvertently
changed.
 Ensure the load is not connected.
 Ensure the power supply is off.
Steps
1. Hold the Function key whilst
turning the power on.
2. The display will show F-90 on the
top and the configuration setting
for F-90 on the bottom.
A
W
V
W
%W10080604020
ISR
C C
DLY
ALM
RMT
C V
VSR
Function OVP/OCP Set
Output
PWR DSPLLock/LocalTest
PSW 3 0-36
360W
Voltage
Current
Multi-Range DC Power Supply
3. Rotate the Voltage knob to change
the F setting.
Voltage
Range
F-90~ F-95
4. Use the Current knob to set the
parameter for the chosen F setting.
Current
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com