PSW Series User Manual
132
PSWSwitch
Analog
connector
24
2
Output
Terminal
2 core shielded
wire or twisted
pair
Pin2 → Switch
Pin24 → Switch
Wire shield → negative (-) output terminal
1. Connect the external switch according to the
connection diagrams above.
Set F-94 (External output logic) in
the power on configuration
settings to 0 (High = On) or 1
(Low = On).
Be sure to cycle the power after
setting the power on
configuration settings.
2. Press the Function key and confirm
the new configuration settings.
3. The switch is now ready to set the output on or
off.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
