PSW Series User Manual
60
Before setting the power supply to C.V. mode,
ensure:
The output is off.
The load is connected.
1. Press the Function key. The
Function key will light up.
2. The display should show F-
01 on the top and the
configuration setting for
F-01 on the bottom.
3. Rotate the Voltage knob to change
the F setting to F-03 (V-I Mode
Slew Rate Select).
4. Use the Current knob to set the F-
03 setting.
Set F-03 to 0 (CV High Speed
Priority) or 2 (CV Slew Rate
Priority).
0 = CV High Speed Priority
2 = CV Slew Rate Priority
5. Press the Voltage knob to save the
configuration setting. ConF will be
displayed when successful.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
