GW Instek PSW 30-72 - Page 33

REMOTE CONTROL
33
2. Press the Function key to enter the
Normal configuration settings.
Page 21
Set the following LAN settings:
F-36 = 1
Enable LAN
F-37 = 1
Turn DHCP to enable
F-59 = 1
Turn the web server on
Note
It may be necessary to cycle the power or refresh
the web browser to connect to a network.
Sockets Server Configuration
Configuration
This configuration example will configure the
PSW sockets server.
The following configuration settings will
manually assign the PSW an IP address and
enable the socket server. By default, the socket
server port number is 2268 and cannot be
configured.
1. Connect an Ethernet cable from the
network to the rear panel Ethernet
port.
LAN
2. Press the Function key to enter the
Normal configuration settings.
Page 21
3. Set the following LAN settings:
F-36 = 1
Enable LAN
F-37 = 0
Disable DHCP
F-39 = 172
IP Address part 1 of 4
F-40 = 16
IP Address part 2 of 4
F-41 = 5
IP Address part 3 of 4
F-42 = 133
IP Address part 4 of 4
F-43 = 255
Subnet Mask part 1 of 4