15
Accounting Enable:
251 (Packets)
The output shows that a total of 251 packets match ACL 3000.
{ On Ten-GigabitEthernet 2/0/1 of Device C:
<Sysname> display qos policy interface ten-gigabitethernet 2/0/1
Interface:ten-gigabitethernet2/0/1
Direction: Inbound
Policy: count
Classifier: count
Operator: AND
Rule(s) : If-match ACL 3000
Behavior: count
Accounting Enable:
50 (Packets)
The output shows that a total of 50 packets match ACL 3000.
4. Compare the traffic statistics on the two interfaces. Packet loss or forwarding fault exists
between Device B and Device C.
Related commands
This section lists the commands that you might use for troubleshooting ACLs.
Command Description
display acl
Displays configuration and match statistics for ACLs.
display diagnostic-information
Displays operating statistics for multiple feature modules in
the system.
display packet-filter
Displays whether an ACL has been successfully applied to
an interface for packet filtering.
display qos-acl resource
Displays QoS and ACL resource usage.
display qos policy global
Displays information about global QoS policies.
display qos policy interface
Displays information about the QoS policies applied to an
interface or to all interfaces.
display qos policy user-defined
Displays user-defined QoS policies.
display qos vlan-policy
Displays information about QoS policies applied to VLANs.
display traffic classifier
user-defined
Displays traffic class configuration.
display traffic behavior
user-defined
Displays traffic behavior configuration.
Troubleshooting IRF
This section provides troubleshooting information for common issues with IRF.
To Next Page
Loading...
Need help?
General