30
If the number of pause frames is accumulating, you can determine that the port has sent or
received a large amount of flow control frames.
b. Verify that the incoming traffic and outgoing traffic have not exceeded the maximum traffic
processing capability of the local device and the peer device.
6. If you determine that the configurations, the peer port, and the link are correct but the issue
persists, perform the following tasks:
a. Use the display diagnostic-information command to collect the diagnostic
information.
b. Contact H3C Support.
<Sysname> display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:Y
Failure to receive packets
Symptom
A port is up, but it cannot receive packets.
Troubleshooting flowchart
Figure 16 Troubleshooting the failure to receive packets
Solution
To resolve the issue:
1. Examine the packet statistics of the port:
To Next Page
Loading...
Need help?
General