H3C UniServer R4900 G3 User Manual

50
Figure 85 Deleting a RAID array
Uninitializing drives
IMPORTANT:
When the
storage controller operating mode is HBA, you cannot uninitialize drives. To uninitialize
the
se drives, you must first set the storage controller operating mode to RAID: hide RAW, RAID:
expose RAW, Auto Volume, or Simple Volume.
Perform this task to clear data, Adaptec metadata, and reserved space on drives, and remove the
system partitions. After a drive in Ready state is uninitialized, it returns to the raw state.
To uninitialize drives:
1. On the PMC RAID management screen, select Logical Device Configuration, and press
Enter.
2. On the screen as shown in Figure 86, select Uninitialize Drives, and press Enter.

H3C UniServer R4900 G3 Specifications

General

Brand	H3C
Model	UniServer R4900 G3
Category	Server
Language	English