EasyManuals Logo

H3C UniServer R4900 G3 User Manual

H3C UniServer R4900 G3
401 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #387 background imageLoading...
Page #387 background image
5
Figure 5 Manage Arrays screen
 If the operating system is installed on a physical drive, select Select Boot Device and
press Enter to open the screen as shown in Figure 6. The first drive in the Selected Drives
area on the right is the first boot option.
Figure 6 Select Boot Device
Replacing a storage controller
1. Replace the storage controller.
For more information, see the storage controller replacement procedure in the user guide for
the server.
2. Configure the storage controller. Make sure the replaced and the newly installed storage
controller operate in the same mode and have the same firmware version.
3. Configure the first boot option. Make sure the first boot option remains unchanged after the
storage controller replacement.

Other manuals for H3C UniServer R4900 G3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C UniServer R4900 G3 and is the answer not in the manual?

H3C UniServer R4900 G3 Specifications

General IconGeneral
BrandH3C
ModelUniServer R4900 G3
CategoryServer
LanguageEnglish

Related product manuals