284
PARAMETERS
June 1999
96-8000
Parameter 137 A EXACT STOP DIST.
These parameters control how close each axis must be to its end point when exact stop is
programmed. They apply only in G09 and G64. They are in units of encoder steps. A value of
34 would give 34/138718 = 0.00025 inch.
Note: To change the values of parameters 134-137 permanently the machine must be
rebooted.
Parameter 138 X FRICTION COMPENSATION
Parameter 139 Y FRICTION COMPENSATION
Parameter 140 Z FRICTION COMPENSATION
Parameter 141 A FRICTION COMPENSATION
These parameters compensate for friction on each of the four axes. The units are in 0.004V.
Parameter 142 HIGH/LOW GEAR CHANG
This parameter sets the spindle speed at which an automatic gear change is performed.
Below this parameter, low gear is the default; above this, high gear is the default.
Parameter 143 DRAW BAR Z VEL CLMP
This parameter sets the speed of the Z-axis motion that compensates for tool motion during
tool clamping. Units are in encoder steps per second.
Parameter 144 RIG TAP FINISH DIST
This parameter sets the finish tolerance for determining the end point of a rigid tapping
operation. Units are encoder counts.
Parameter 145 X ACCEL FEED FORWARD
Parameter 146 Y ACCEL FEED FORWARD
Parameter 147 Z ACCEL FEED FORWARD
Parameter 148 A ACCEL FEED FORWARD
These parameters set the feed forward gain for the axis servo. They have no units.
Parameter 149 PRE-CHARGE DELAY
This parameter sets the delay time from pre-charge to tool release. Units are milliseconds.
Parameter 150 MAX SP RPM LOW GEAR
Max spindle RPM in low gear.
Parameter 151 B SWITCHES
See Parameter 1 for description.