Hach 2100Q - USB+Power module components; Installation; Install the battery

Figure 2 USB module components
1 USB module
1
3 USB cable, type A receptacle to
USB mini B plug
2 USB cable, type A plug to USB mini
B plug
1
Not available in all regions
USB+Power module components
N O T I C E
The manufacturer recommends to use only the supplied power supply (LZV803).
Refer to Figure 3 to make sure that all components have been received.
If any of these items are missing or damaged, contact the manufacturer
or a sales representative immediately.
Figure 3 USB+Power module components
1 USB cable, type A plug to USB mini
B plug
3 USB+Power module
1
2 USB cable, type A receptacle to
USB mini B plug
4 AC adapter plugs
(EU/USA/UK/AUSTRALIA) and AC-
DC power supply
1
Not available in all regions
Installation
Install the battery
W A R N I N G
Potential fire hazard. Use only alkaline or nickel metal hydride batteries (NiMH) in
the meter. Other battery types or incorrect installation can cause a fire. Never mix
battery types in the meter.
N O T I C E
The battery compartment is not waterproof. If the battery compartment becomes
wet, remove and dry the batteries and dry the interior of the compartment. Check
the battery contacts for corrosion and clean them if necessary.
English 5