Send data to a PC
Transmit data in storage to a PC and see real-time measurement values from a remote location on a
PC. Refer to the SmartLogger II PC software guide for operation instructions for the PC to USB
connection.
1. Set the power to off.
2. Connect the USB cable to the USB port of the PC.
3. Use the USB drivers to make a USB connection to the PC.
4. Set the power to on. Refer to the SmartLogger II documentation for data transfer information.
Keep measurement data
Keep up to 999 measurement readings to review, download or print later.
1. Push STORE during a data measurement. The meter shows the next available sample number,
then the "?" icon flashes.
2. Push STORE again. The data is kept in that memory location and the meter goes back to the
measurement mode.
3. To keep data in a different sample number, use the number keys to select a different sample
number. Push ENTER to keep the measurement in this memory location.
Note: The meter beeps two times if a sample number already contains data or if all memory locations are full. The
meter will prompt: "DELETE SAMPLE?". Push ENTER to overwrite the data in that location with the current data.
Push CANCEL to exit to keep the current data.
Examples of measurement data
pH and ISE measurements
• Sample number
• pH or ISE value
• mV value (pH)
• Sample temperature
•
Temperature compensation (automatic or manual values)
• Date and time
• Meter serial number
• Probe serial number (ISFET)
• Software version
• Calibration date and time
Conductivity, TDS, salinity and DO measurements
• Sample number
• Conductivity, TDS, salinity or DO values
• Sample temperature
• mV value (pH)
• Temperature normalization (20 to 25 ºC or 68 to 77 ºF)
• Temperature compensation coefficient (conductivity/TDS)
• Salinity adjustment (DO)
• Barometric pressure (DO)
• Calibration date and time
• Meter serial number
• Software version
16 English
To Next Page
Loading...
