EasyManuals Logo

Hach NITRATAX plus sc User Manual

Hach NITRATAX plus sc
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
12
Installation
3.2 Unpack the sensor
Remove the sensor from the shipping container and inspect the sensor for damage.
Verify that all items listed in Figure 5 are included. If any items are missing or damaged,
contact the manufacturer or distributor.
3.3 Wiring safety information
3.3.1 Sensor connection and wiring
The sensor can be connected to any sc controller using the supplied keyed quick-connect
fitting. The sensor can also be hard-wired to an sc 100 or sc 1000 controller (Refer to
Figure 7 for more information).
To attach the sensor to the controller with the quick-connect fitting:
1. Unscrew the protective cap on the socket on the controller (Figure 6). Retain the
protective cap to seal the connector opening in case the sensor must be removed.
Figure 5 Items supplied
1 NITRATAX sc sensor with cable 3 1 wiper set (5 pieces) for 1 or 2 mm (0.04 in. and
0.08 in.) sensors
2 Nitrate standard solution (1 L) 4 1 wiper set (5 pieces) for 5 mm (0.20 in.) sensors
WARNING
Electrical shock hazard. Always disconnect power to the instrument when making any electrical
connections.
CAUTION
Before power is applied, refer to the controller operation instructions.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hach NITRATAX plus sc and is the answer not in the manual?

Hach NITRATAX plus sc Specifications

General IconGeneral
BrandHach
ModelNITRATAX plus sc
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals