Section 5 User interface and navigation
5.1 Keypad
1 Power 3 Selection keys 5 Home key
2 Printer 4 Navigation keys
Key Description
Power Sets the instrument power to on or off. Push the key for 2 seconds to set the power to off.
Printer The printer key only operates if a printer is connected to the instrument. Sends the data currently shown
on the display to a connected printer when pushed. A sound is heard if the current display cannot be
printed. A graph is automatically printed at the end of the measurement, if the option is selected
(Settings > Options).
Selection keys
(contextual)
Used to select options shown above them in the footer bar. The options available are applicable to the
current operation (e.g. calibration, measurement, etc.).
Navigation keys Scrolls through menus and data, enter numbers and letters, enter checkbox settings and set options for
the syringe and the pump.
Home Push this key at any time to go directly to the home screen. A sound is heard if the key is disabled (e.g.
during a calibration or measurement).
5.2 Home screen
1 Available options from this screen 5 Screen name
2 If two syringes are installed, shows applications for
syringe 2
6 Information icons (refer to Table 4)
3 Applications for syringe 1 7 Option available by pushing the selection key below
4 Screen icon 8 Arrow keys available for use in the screen
Table 4 shows the information icons that can be shown in the header bar.
25
To Next Page
Loading...
