18
OPTION 2 - PORTABLE
NOTE: In order for this washer to meet the regulated energy standards, the faucet
supplying the water must be set to cold.
1. Remove the aerator from your faucet nozzle.
2. Examine the faucet to determine if it has internal or external faucet threads.
•
Internal threads - Keep the rubber washer
in place
•
External threads - Remove the rubber washer
before threading the
faucet connector onto the faucet.
a Removable Washer
b Secondary Washer (Do not remove)
c Washer Support (Do not remove)
d Silver Faucet Connector
NOTE: The faucet connector (provided) is threaded so that it will t MOST
faucets. If the provided faucet connector does not t your faucet, you will need
to purchase a faucet connector in the correct size.
3. Thread the silver faucet connector onto the faucet.
Internal Threads External Threads
a Rubber Washer
b Silver Faucet Connector
c Quick-sink Faucet Adapter
d Water Inlet Hose - Gray End Only
4. Attach the quick-sink faucet adapter to the gray end of the inlet hose making
sure the pre-installed at washer is between the hose and the adapter.
5. Attach the quick-sink faucet adapter to the silver faucet connector by pulling
down on the white collar while pushing upwards on the faucet. Release the white
collar and it will lock into place.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
