29
MAINTENANCE
1. Be sure to press POWER to set the player to the standby mode and disconnect the AC
adaptor.
2. Wipe the player with a dry, soft cloth.
3. If the surfaces are extremely dirty ,wipe clean with a cloth which has been dipped in a weak
soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth.
4. Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do not use
compressed air to remove dust
GENERAL TROUBLESHOOTING
Check the following points before assuming malfunctions of the TV set:
Phenomenon Reasons
No picture & sound Improper connection of AC adaptor or the battery power box is
not enough.
No picture TV reception channel is not right and try to reset the unit.
Relocate the
TV set to the place where reception is better.
No sound Volume is too low; Mute function is switched on.
The headphone has been plugged in or the signal is too weak.
Poor reception TV antenna is not correctly adjusted or TV channel is not right.
Dark or blurred picture The bright & contrast is too low. The battery voltage is too low.
Unclear or unstable
picture
TV antenna is not properly adjusted or in too weak signal
reception area.
Picture moves up &
down,blurs or folds
over
TV antenna is not rightly adjusted.
The signal reception is too weak or caused by signal reflection
from the buildings nearby or mountains.
Interfered snow
picture
The signal is interfered by car’s engine, railway, high tension
wires, neon signs or radio frequency.
No color Color or color system is not set properly.
To Next Page
Loading...
