33
Operation
(6) The mode of indoor units can be inquired /changed by the
advanced setting function after the wired controller is powered
on, Only valid for part of models.
(7) Set as follows (Only valid for part of models):
Press Set key and Up key for 5s to enter the advanced setting
state, with the function A in temp. display area displayed
statically. Press Fan key to switch to function B. The function
code 01 displayed in the clock display area will ash. The
specic information in the timing display area is statically
displayed, it can be changed in the range of 00-03 by Up/
Down key. At this time press Set key to conrm, and the
function code 01 in clock display area stays static, the specic
information in the timing display area ashes, meaning it can
be changed currently. Press Up/Down key to change the
content and Set key to conrm.
(8) If the mode is changed from more to less, the current mode
will not be in the mode of the present circulation. It will be the
fan mode after turn on.
To Next Page
Loading...
