Hakko Electronics 936 User Manual

SOLDERING STATION
Instruction Manual
Thank you for purchasing the HAKKO 936 Soldering Station.
Please read this manual before operating the HAKKO 936.
Store the manual in a safe, easily accessible place for future reference.
Packing List/Specifications ……………………1
Precautions………………………………………2
Names of Parts …………………………………3
Setting up & Operating the HAKKO 936……3 4
Tip Care and Use
Maintenance
Calibrating the Iron Temperature…………5
Tips ………………………………………………6
Troubleshooting Guide…………………………7
Checking for breakage of the
heating element and cord assembly……8 9
Parts List
Station / Iron Holder………………………10
Iron…………………………………………11
Wiring Diagram…………………………………11
Table of Contents
®

Hakko Electronics 936 Specifications

General

Heating Element	Ceramic
Tip to Ground Resistance	<2 ohms
Tip to Ground Potential	<2mV
Weight	1.2 kg (excluding power cord)
Temperature Range	200-480°C (400-900°F)

Summary

Packing List

Specifications

Station

Details about the HAKKO 936 soldering station specifications.

Soldering Iron

Specifications for the different HAKKO soldering iron models.

Precautions

Names of Parts

Setting up & Operating the HAKKO 936

A. Iron Holder

Instructions for setting up the iron holder, including sponge preparation.

B. Connections

Steps for connecting the soldering iron cord and power supply.

C. Set the Temperature

Procedure for setting and locking the desired temperature.

D. Turn on the Power Switch.

Instructions for turning on the unit and indicators.

Tip Care and Use

Tip Temperature

Guidance on using appropriate soldering temperatures to protect the tip.

Cleaning

Instructions for cleaning the soldering tip regularly.

When Not in Use

Advice on handling the iron when not actively soldering.

After Use

Steps for post-use tip maintenance to prevent oxidation.

Maintenance

Inspect and Clean the Tip

Procedure for inspecting and cleaning the soldering tip.

Calibrating the Iron Temperature

Tips

Troubleshooting Guide

Problem 1. The heater lamp does not light up.

Troubleshooting steps for when the heater lamp fails to illuminate.

Problem 2. The heater lamp lights up but the tip does not heat up.

Steps to diagnose why the tip is not heating.

Problem 3. The tip heats up intermittently.

Guidance for intermittent tip heating issues.

Problem 4. The tip is not wet.

Troubleshooting tips for a non-wet soldering tip.

Problem 5. The tip temperature is too low.

Steps to address low tip temperature.

Problem 6. The tip can not be pulled off.

Solutions for a seized or stuck soldering tip.

Problem 7. The tip doesn't hold the desired temperature.

Diagnosing and fixing temperature holding issues.

Checking for breakage of the heating element and cord assembly

Disassembling the 900S

Broken Soldering Iron Cord

Replacing the Fuse

Parts List (Station/Iron Holder)

Parts List (Iron)

Wiring Diagram