To Next PageTo Next Page
Need help?Do you have a question about the Hakko Electronics FR-803 and is the answer not in the manual?
General| Brand | Hakko Electronics |
|---|---|
| Model | FR-803 |
| Category | Soldering Gun |
| Language | English |
Defines WARNING, CAUTION, NOTE, and EXAMPLE terms used in the manual.
Lists essential precautions to avoid injury, death, or equipment damage during operation.
Identifies the main components of the HAKKO FR-803 station using diagrams.
Identifies the main components of the HAKKO FR-803 handpiece using diagrams.
Provides detailed explanations for the functions of the station's various parts.
Provides detailed explanations for the functions of the handpiece's various parts.
Instructions for attaching the handpiece holder to the main station unit.
Steps for attaching nozzles and pads to the handpiece for operation.
Explains how to select between MANUAL, INSTALL (AUTO), and REMOVE (AUTO) operating modes.
Details how to start and stop air blow and vacuum functions in MANUAL mode.
Guides on setting temperature profiles for the AUTO mode file programs.
Explains the process of selecting and initiating changes to AUTO mode files.
Describes how to check saved temperature and timer data for AUTO mode files.
Details how to modify unit parameters like temperature units and power saving time.
Provides instructions to reset the unit to factory default settings.
Guides on setting an offset value for temperature calibration in MANUAL mode.
Instructions for disassembling the handpiece to inspect and test heater/sensor resistance.
Outlines the procedure for safely replacing the unit's fuse.
Addresses common operational problems like unit non-response or profile setting failures.
Provides troubleshooting steps for sensor and heater error codes.
Lists and illustrates various optional nozzles designed for vacuum pickup applications.
Lists and illustrates optional nozzles that do not utilize the vacuum function.
