Need help?Do you have a question about the Hakko Electronics FX-951 and is the answer not in the manual?
General| Brand | Hakko Electronics |
|---|---|
| Model | FX-951 |
| Category | Soldering Gun |
| Language | English |
Procedure to access and modify station parameters.
Configure the time delay before activating sleep mode.
Set tolerance for low tip temperature alerts.
Set supervisor or operator control mode.
Configure buzzer for sensor or iron errors.
Configure buzzer for set temperature alerts.
Verify the integrity of the heater and sensor by resistance.
Verify the electrical integrity of the grounding line.
Check the connection cord for continuity and breakage.
Procedure for safely replacing the fuse.
Indicates a failure in the sensor or heater circuit.
Indicates tip temperature fell below the set tolerance.
Indicates a short circuit in the heater terminal.
Indicates connector issue or incompatible iron.
Details of Shape B tip styles and dimensions.
Details of Shape BC tip styles and dimensions.
Details of Shape C tip styles and dimensions.
Details of Shape D tip styles and dimensions.
Details of Shape I tip styles and dimensions.
Details of Shape J tip styles and dimensions.
To Next Page
