3 Scan mode (reading mode)
3.1 Manual
Manual reading mode is the default reading mode. In this mode, the HBCS2D100U starts reading the code
after pressing the trigger key, and stops the reading after the reading code successfully outputs the message
or releases the trigger key.
* Manual
In this mode, HBCS2D100U default idle for a certain period of time, automatically enter the deep sleep
mode, can be set by the following setup code.
After entering sleep mode, wake up by pressing the key, the device will reboot after exiting sleep mode.
In addition, when deep sleep is not enabled, you can also set the light sleep idle time by scanning the
following setting codes.
To Next Page
Loading...
