3.3 Autosensing Mode
After setting, without trigger, the reader immediately began to monitor the brightness of the surrounding
environment, when the scene changes, the reader waits for the set of image stabilization time after the end of
reading. After reading the successful output of information or single reading time-out after the reader to be
some time interval (can be set) to re-enter the monitoring state. If the following conditions do not occur, the
reader will cycle in the above way: In a single reading time bar code is not scanned, the reader will automatically
pause reading and into the monitoring state. In the inductive reading mode, the reader can also start reading
the code after pressing the trigger key, and continue to monitor the brightness of the surrounding environment
when the reading code successfully outputs the message or release the trigger key.
Autosensing mode
Single reading time
In inductive reading mode, this parameter refers to the maximum length of time that the reader will be
allowed to continue acquisition recognition before the reading is successful. After a successful reading or a
single reading timeout, the reader will enter the interval of not acquiring readings.
Single reading time length setting range of 0.1 ~ 25.5 seconds, step 0.1 seconds. When set to 0, the
reading time is infinite. The default duration is 5.0 seconds.
Reading interval length
After reading the successful output of information or single reading time-out, the reader needs to be some
time (can be set) to re-enter the monitoring state. The reading interval setting range is from 0 to 25.5 seconds
in 0.1 second steps. The default interval is 1.0 second.
To Next Page
Loading...
Need help?
General
