3.2 Successive scanning mode
After setting, without trigger, HBCS2D100U reader immediately start reading, reading code successfully
output information or single reading time after the end, HBCS2D100U wait for a period of time (can be set) will
automatically start the next reading. If the following conditions do not occur, HBCS2D100U reader will work in
the above cycle: During reading the user can also click the trigger button to manually pause the reading. Click
the trigger button HBCS2D100U will continue to cycle reading.
Successive Scanning mode
Single reading time
In continuous reading mode, this parameter refers to the reading before the success of HBCS2D100U
reader to allow continued recognition of the maximum acquisition time. After a successful reading or a single
reading time-out, the HBCS2D100U reader enters the interval of not acquiring readings. Single reading time
length setting range of 0.1 ~ 25.5 seconds, step 0.1 seconds; when set to 0, said the reading time unlimited.
The default duration is 5.0 seconds.
Reading interval length
This parameter refers to the interval between two adjacent readings, that is, after finishing the last reading
of the reader (no matter the reading is successful or not), the reading will not be carried out within the set
interval, until the interval ends After reading the next code. The reading interval setting range is from 0 to 25.5
seconds in 0.1 second steps. The default interval is 1.0 second.
To Next Page
Loading...
Need help?
General
