Hamlet HBCS2D100US - Appendix A: Default Settings Table

9 Appendix A: Default Settings Table
Format 9-1 Default settings table
parameter name
default setting
Noted
Interface
TTL-232
Baud rate
9600
Inspection
Not inspection
Data bit
8 bits
Stop bit
1 bit
Hardware flow
control
Not
Mode parameters
The default mode of reading
Manual Mode
Serial trigger
mode
Single reading
time
5s
Parameter range: 0.1-25.5 seconds,
step is 0.1s; 0 means that the single
decoding time is not limited
Manual Mode
Trigger level
Low trigger
The default high level