Hamlet HBCS2D100US User Manual

7.7 Output protocol
The following setting code can be used to modify the output format of the decoding result in serial / virtual
serial port mode by scanning.
The format of the output with protocol is selected as follows: <03> <Length> <Decode Data>.
In addition, when the output with protocol is enabled in serial / virtual serial port mode, the module will not
add an ending character to the decoded data.
* Pure data
With agreement
7.8 UPCA convert to to EAN 13
You can enable or disable UPCA conversion to EAN13 by scanning the following setting code.
Enable
Disable
7.9 Product code verification output enable
The output of the product code parity bit (including EAN8/EAN13/UPCE0/UPCE1/UPCA) can be enabled
by scanning the following setting code.
Enable
Disable

Hamlet HBCS2D100US Specifications

General

Brand	Hamlet
Model	HBCS2D100US
Category	Barcode Reader
Language	English