7.2 Suffix
Add a suffix
The suffix is a string that is customized and modified by the user after the information is decoded, and can
be added by scanning the "allow suffix" setting code
* Not allow to add a suffix
Modify the suffix
Scan the "Modify Suffix" setting code, and set the scan data setting code, the user can modify the suffix
content, use two hexadecimal values for each suffix character, suffix up to 15 characters, character value
hexadecimal conversion table Please refer to Appendix D.
Modify the suffix
Example: Modify user-defined suffix "DATA"
1. Check the character table to get "DATA" four characters hexadecimal value: "44", "41", "54", "41"
2. Check whether the setting code is on. If it is not on, please scan the setting code "On" (see section 1.5.2)
3. Scan the "Modify Suffix" setting code
4. Scan the data setting codes "4", "4", "4", "1", "5", "4", "4", "1"
5. Scan "Save" setting code
To Next Page
Loading...
