Need help?Do you have a question about the Hammer A3-26 and is the answer not in the manual?
Defines the machine's specific purpose and prohibits misuse.
Defines the operator's duties for safe machine operation.
Lists required PPE for safe operation.
Identifies electrical hazards and safety precautions.
Details risks like knife contact, ejected workpieces, and noise.
Details the function of safety break switches.
Describes the bridge guard and its adjustment.
Describes the kickback guards and their protective function.
Instructions for connecting the dust extraction system.
Safety and procedure for electrical hook-up.
Safety guidelines for adjustments and setup.
How to set the cutting depth using the adjustment wheel.
Procedure for setting the planer table for precise joints.
Method for setting the thicknessing table height.
Steps to convert the machine from planing to thicknessing.
Steps to convert the machine from thicknessing to planing.
Instructions for setting up the drilling unit.
Steps to switch back from drilling operation.
Critical safety rules for operating the machine.
Procedure for powering up the machine correctly.
How to safely stop the machine, including emergency procedures.
Detailed steps for planing workpieces up to 75mm.
Detailed steps for planing workpieces over 75mm.
Procedure for achieving precise joints on workpieces.
Safety precautions when dealing with machine faults.
Immediate steps to take when a fault occurs.
Troubleshooting table for common machine issues.
Guidance on knife maintenance for optimal results.
Procedure for reversing or replacing system planer blades.
Procedure for sharpening or changing standard planer knives.
To Next Page
General