Hammer A3-31 User Manual

4
Planer-Thicknesser
A3-26 / A3-31 / A3-41
6 Transport, packaging and storage ................................................................. 25
6.1 Safety instructions ........................................................................................................25
6.2 Transport .....................................................................................................................25
6.3 Transport inspection ......................................................................................................27
6.4 Packaging ...................................................................................................................27
6.5 Storage .......................................................................................................................27
7 Setup and installation ................................................................................... 28
7.1 Safety instructions ........................................................................................................28
7.2 Setup ..........................................................................................................................28
7.3 Chip extraction ............................................................................................................30
7.4 Electrical connection .....................................................................................................31
7.4.1 Alternating-current motor ..........................................................................................31
7.4.2 Three-phase alternating current motor ........................................................................31
8 Making adjustments and preparations ........................................................... 32
8.1 Safety instructions ........................................................................................................32
8.2 Adjusting the depth of cut ..............................................................................................32
8.3 Adjusting the joint ........................................................................................................33
8.4 Adjusting the planer fence .............................................................................................34
8.4.1 Adjusting the angle .................................................................................................34
8.4.2 Sliding ...................................................................................................................34
8.5 Adjust the thicknessing height ........................................................................................35
8.6 Adjusting the drilling support .........................................................................................36
8.7 Retooling from a planer to a thicknesser ..........................................................................37
8.8 Retooling from a thicknesser to a planer ..........................................................................38
8.9 Retooling to the drilling unit ...........................................................................................39
8.9.1 Mounting the mortising support .................................................................................39
8.9.2 Clamp the drilling tool .............................................................................................39
8.10 Retooling from a drilling operation to a planer or a thicknesser operation ..........................40
9 Operation .................................................................................................... 41
9.1 Safety instructions ........................................................................................................41
9.2 Switching on the machine .............................................................................................42
9.3 Switching off the machine / EMERGENCY-STOP ..............................................................42
9.4 Surface planing ...........................................................................................................43
9.4.1 Working position ...................................................................................................43
9.4.2 Workpiece dimensions ............................................................................................43
9.4.3 Authorised and prohibited work techniques ................................................................43
9.4.4 Surface planing - Workpieces up to 75 mm thick ........................................................44
9.4.5 Surface planing - Workpieces over 75 mm thick ..........................................................45
9.4.6 Jointing ..................................................................................................................46
9.4.7 Bevelling/Chamfering ..............................................................................................47
9.4.8 Tapering/beveling small workpieces ..........................................................................48
9.5 Thickness planing .........................................................................................................48
9.5.1 Workpiece dimensions ............................................................................................48
9.5.2 Authorised and prohibited work techniques ................................................................48
9.5.3 Work place/work position .......................................................................................49
Table of contents

Hammer A3-31 Specifications

General

Max. planing width	310 mm
Total length of tables	1400 mm
Max. depth of cut	4 mm
Tersa cutterblock with reversible blades	Yes
Number of blades	3
Max. planing depth	4 mm
Planer knife length	310 mm
Motor power	3 kW
Frequency	50 Hz
Planing fence tiltable	90°–45°