Planer-Thicknesser
A3-26 / A3-31 / A3-41
10 Service
Warning! Risk of injury! Improper maintenance can cause serious injury or damage. For this reason, this
work may only be carried out by authorised, trained personnel who are familiar with how to operate the
machine and in strict observance of all safety instructions.
10.1 Safety instructions
• Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
• Keep the work area orderly and clean Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
Warning! Danger! Electric current:
Work on electrical fittings may only be carried out by qualified personnel and in strict observance of the
safety instructions.
• Ensure that there is sufficient space to work around
the machine.
• Following the maintenance work, reinstall the guards
and check that they are functioning properly.
10.2 Maintenance schedule
Note: Cleaning and care products are available as accessories.
(See Tools and Accessories catalogue)
Interval Component Task to accomplish
Daily Machine Remove dust and shavings
Table surfaces Remove dust and shavings
Planer fence Remove dust and shavings
Dust extractor Check for defects
Kickback guards Check if functioning, if necessary remove
any resin residue
Monthly OR:
approx. Every 40 operating
hours
Dust extractor Check efficiency
Drive belt Check, if necessary: readjust the tension or
replace
Feed rollers Remove any resin residue
Height spindle (Thicknesser table) Control and lubrication (if required)
Height spindle (Mortising table) Control and lubrication (if required)
Guides (Mortising table) Clean
Every 6 months Chain (Gearbox) Check and lubricate if necessary
Friction wheel (Gearbox) Check and exchange if necessary
Poorly planed surface System planer knives Check and if necessary reverse or replace
Standard planer knives Check and if necessary, sharpen or replace
Service
To Next Page
Loading...